Minolta Multi Pro Scanner Problem - Too Redish and Dark Scanned Images

What about contacting Minolta - multiple options at this link: (Minolta Support and Downloads) index If no satisfactory answer consider returning printer.

I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

Have you cleaned the scanner glass bed lately?

Need help with image pro 11 multi gym need the instructions have lost them?

If the scanner is completely locked up, you need to reinitialize it, but be aware that this procedure will erase/delete all information that you've programmed into it. To initialize the scanner:

1. Turn off the scanner, then turn it on again. Multi-system
Trunking Scanner appears.
2. Press 0 while Multi-system Trunking Scanner appears.
3. Press 1.
4. Press ENT. Initializing please stand by. appears for about 5
seconds.
Do not turn off the scanner until the initalization is
complete. When the initialization is complete, M000
appears on the top line of the display. Bank 0 Ch 00
appears on the third line.

Need the complete manual for your scanner? You can download/print it here:

http://scancat.com/OnLineHelp/OEM_Radio_Owners_Manuals/PRO-97_OwnersManual_ome20-527.pdf

For a comprehensive database of active frequencies and systems in your area, along with a lot of useful scanning data, visit:

www.RadioReference.com

Bill B

I have the same problem with mine; medium format scans are fine but 35mm scans are stretched. The same happens with both the Minolta software and with Vuescan. Has anyone manage to fix this?

If some particles of dust stick to the scanning module, then while scanning they appear like lines. Clean the scan module thoroughly using Isopropyl alcohol IPA-Industrial grade is enough, dont use any solvent. You can use your aftershave (!) once or twice. Ensure that the film strips are not sticky.

S. Mohan, Chennai, India

I no the older Minolta's had an aperture problem the pictures when zooming out after they were developed were very dark. But inside and wide angel shots always came out nice I had to have the aperture base plate replaced on my Minolta Maxxum 3000i my point and shooter, I wish this helped but it sounds like something different in your case it also maybe the aperture acting different in your camera than it did in 1 of mines.

Initially, I get a green flashing light when unit turned on, but after a minute or so, it turns to a red flashing light. It will take in the film tray only when blinking red, not when blinking green. My iMac has a hard time seeing the scanner, keep getting "scanner not found" messages. I have to go to system profiler and have it refresh and then it finds it, then the scanner software sees it too. But I have been unable to one preview out of it, says LED error and that's it. Using 10.4.10 on an iMac 20" with 2.5gb of RAM, using Pshop CS2 or going through Minolta Driver of OSX I got off of VersionTracker. I did remove the screw for transport right away. Will feed in 35mm tray with red blinking light, will not feed in 120 tray except partially with red blinking light, and only a couple times out of maybe ten tries.

Hello, Verify with the manufacture of the scanner to see if you have the proper driver(s) for the scanner, also if its compatible with your OS version.