OpenOffice Printing Problem

Solution
The possible reasons for this error message are as follows:

• The document is containing both image and text.
  
• The font is not supported.
  
• Embedded fonts are used.
  
• A special plug-in is used.
  

This issue can be fixed by enabling the following option in Printer Preferences .
To access Printer Preferences , follow these steps:

1. Open the Control Panel .
   
2. Open Printers and Faxes .
   
3. Right-click HP Color LaserJet CM2320 MFP Series PCL 6 , and select Printing Preferences .
   
4. Under the Advanced tab, change the Print Data Optimization from Auto to Optimize for Text and Vector .
   
5. Now try printing the document.
   
6. If the document did not print then try turning the printer off then back on. Try printing the document again.
   

Rameshkumar . R
[email protected]

Try if one of these solutions help you.
1. Shut down you printer, wait a few seconds, start it again and try to see if you document is printing.
2. Install the printer again on your computer. This time, if possible use an other USB port.
3. If you can print PDF, you can try http://www.freepdfconvert.com/ and print your document after you mad a PDF.

there is a printer options at control panel, try to see if the setting is printing immediately,...

Counter reach its preconfigured limit it is just, you have to reset the counter back to zero count. This feature could be attributed not to overflow the waste bin.

In your web browser search bar, key in " epson reset software" the uppermost link is the one. Read the tutorial before doing so.

Hope you get it easily.

If that's the only error message that you are receiving, I would recommend removing and re-installing the printer software.

Turn it off and unplug it for about 30 seconds. Plug it back in, turn it on and try printing a Self-Test (Setup, 2, 5). If this works, try printing your document again.

In Print settings if using PCL select Print as Image. Also Spool Printing. Use PCL5e or PS drivers.

try setting the driver to KPDL mode in the settings section of the driver

I too have problem when printing multiple copies. Word just crashes out.

Any ideas how to fix???

try using only one type of connection (USB or FireWire) see if that helps.

no known conflict for DivX for the printer, not sure for the mac though