Xbox nat setting moderate; NEED TO ENABLE UPnP

In order to open NAT settings for the xbox 360 you will need to enable Universal Plug N Play [UPnP]

To enable this setting in the Belkin DIR-628:

1. Log into the router
2. Click on the "Advanced" Menu on top
3. Click on the Enable UPnP: Checkbox
4. Click on the Save Settings Button

You'll need to log into the linksys router and find the setting for UPNP. Please make sure this is enabled. That should allow your NAT setting to at least Moderate, if not Open.

try this option as follows:-- just enable the NAT settings from Strict to Open:-

1. Log into router's IP address (192.168.1.1) and enter password. Select "Advanced Setup".

2. Click on Advanced on left hand menu and select UPnP

3. Check all three boxes in window and click on Apply

4. Close router configuration window and run xbox test again.
click on this link directly for more detailed help xbox-live-compatible/">http://midnight.hushedcasket.com/2007/01/30/make-your-router-xbox-live-compatible/


This will help. Thanks please keepupdated.please do rate the solution positively .thank you for using fixya

yo tengo problema co el asistente de conexion del linksys

This one is simple. Find the IP address that your Xbox is assigned by your router, then put it into the DMZ. This also goes for PS3 users who are having trouble with internet access.

You need to open all the ports for the xbox live. The NAT of that router model cannot be configured to open. Its just a simple NAT for internet connection.

Have you called linksys regarding this problem? Try this http://technicalsupport.blog.friendster.com

Enable UPnP.....UPnP can help make sure NAT works correctly for Xbox LIVE. Usually, this can be set on your router configuration web page, which is supplied by your router manufacturer.

go into the router settings and look for uPnP and enable this it will then open the firewall for your xbox automatically

upgrade your router to the latest firmware that can be found here:
http://kbserver.netgear.com/products/WGR614.asp

after upgrading the firmware, press the reset button for 30 seconds, then reconfigure the router. you will need to re-enable upnp if it is disabled, and open up ports UDP 88 UDP 3074 TCP 3074. i would also reserve the ip for the xbox and if all else fails set the xbox as the dmz host.

hope this helps,
trin