Hp psc 1315 prints blank pages

1.Download from here the correct driver

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=374569&lang=es&cc=mx&taskId=135&prodTypeId=18972&prodSeriesId=360489

2.Uninstall all about hp printer software that you have

3. Power cycle the Pc

4. Reinstall the new downloaded driver

5. Finally plug in the printer and turn it on

check the page setup and try again................
A4 and Letter

Thanks

please check the ink levels in your catridge. if they are low , replace them

If your printer support printing on both side. Uncheck Print on both sides. File -> Print -> Properties button -> Finishes tab.

Hi Siddarth

In HP PSC 1315 printer after replacing new Ink Cartridges the printer always prints Alignment test page every time you turn it ON.To resolve this problem you must complete the alignment process.

Steps

1.Turn the printer ON.
2.Once its ON, it will print the Alignment page. Place the page in the scanner bed correctly.
3.Then Press START SCAN button.
4.The power light will start blinking, wait until the power lights turns solid.
5.Now Alignment process is over.Discard the paper from scanner.
6.Turn the printer OFF and then ON, it will not print that page again.

Note:Please follow this steps every time when you replace the Cartridges.

Thanks
Rizwan
[email protected]

Try uodating your printer drivers ,Try to change default printer

reinstall the driver

Click Start - All programs - HP - HP Director/Solution center

Click Settings - Print settings - Printer settings

Click on the Colors. In Color Management select "Managed by Application". Click Apply and OK. Close HP Director/Solution center.
Try printing.

hp psc 1315 printer dead due to lighting send me circuit drawnig

You need to put the test page that was printed into the scanner part of the printer and then press the scan/blue button. This is so the printer can calibrate the new ink. When you have done that the next time you turn on the printer a blank page will not be printed. When you next change ink you will have to repeat the above procedure.