Kyocera fs-1016MFP printer error service call 7980

Check this pdf
https://www.google.gr/url?sa=t&rct=j&q=&esrc=s&source=web&cd=1&cad=rja&uact=8&ved=0CCAQFjAA&url=http%3A%2F%2Fwww.diagramasde.com%2Fdiagramas%2Fotros2%2FService%2520Manual%2520FS-1016EN.pdf&ei=57nXU-S_MYj9ygP4yILYBw&usg=AFQjCNEJEfHI-JBO5wAgJrl8GtSiN847Xg&sig2=1AjtVPSzEtEcdpGaZJrjVQ

Spefically read page 1-5-8 until 1-5-12

Have you tried just setting it up as an HP? Kyocera machines emulate HP.

Error de llamada 7980 en kyocera fs 1016 mfp

Code: 6000
Contents: Broken heater lamp error
The temperature won't rise by 1°C/33.8
°F during warming up and the heater is
turned on for 5 seconds.
The temperature won't rise by 1°C/33.8
°F during printing and the heater is
turned on for 5 seconds with the duty
cycle more than 60%.

Causes:
- Defective fuser thermistor.
- Broken thermal cutout or heater lamp.
- Defective engine/high voltage PWB.

Broken heater lamp error
The temperature won't rise by 1°C/33.8
°F during warming up and the heater is
turned on for 5 seconds.
The temperature won't rise by 1°C/33.8
°F during printing and the heater is
turned on for 5 seconds with the duty
cycle more than 60%.

Causes:
- Defective fuser thermistor.
- Broken thermal cutout or heater lamp.
- Defective engine/high voltage PWB.


Follow the flow chart:

Turn power switch off, and
remove power cord.

Detach YC7 connector on
the engine/high voltage
PWB.

Measure resistance
between pins 1 and 2 of
the detached connector.

Open
(infinite)?

Yes ---> Replace the fuser thermistor.
NO ----> Detach YC1 connector on the power source PWB.

Measure resistance
between pins 1 and 2 of
the detached connector.

Open
(infinite)?

Yes ---> Replace the thermal cutout or heater lamp.
NO ----> Replace the engine/high voltage PWB.

this problem means wast toner is full meaning Total page count less
than 100,000 pages of printing

try to download on kyocera web site for your need.

If you do not have the CD that came with the machine, you are pretty much out of luck.

Try www.kyoceramita.com and look for drivers

Your drum unit is not seated correctly. Look inside for a bent drum ground clip.