When blinks red ! with beep codes present
Http://www.kyoceramita.eu/dlc/eu/documentation/installationmanual/fs-3820n-3830n-ig-uk.-downloadcenteritem-Single-File.downloadcenteritem.tmp/FS-3820N-3830N-IG-UK.pdf
Hi Try this link and hope it will help youKind regardsMichelle
Kyocera Mita FS-3820N
Hello,
This error code (7001) refers to a Toner
motor error.
• Toner motor is overloaded. TNMOC is detected
by sampling every other
100 ms in 2 seconds since the main and toner
motors are activated following
the Replace toner Clean printer, message after
the "Toner low" is detected.
Recommended action is to change the
toner pack.
If this does not resolve the issue then the developer
should be changed.
If neither of those resolve the issue, then
likely the internal circuit board called the engine controller may be bad.
If this is the case the printer will need to
go to an Kyocera Repair Depot.
I hope this has been of assistance.
http://www.fixya.com/uploads/images/prefab_21.jpg
339 views
Usually answered in minutes!
×