EVERYTHING IS CONNECTED AND NETWORK LOOKS CONFIGURED CORRECTLY.
PRINTER SCANS AND THEN AFTER AWHILE IT FLASHED ERROR SENDING 2101
2101, 2102, 2103, 2201, 2202, 2203, 3101:
The network cable is disconnected or the hub that it is connected to is not operating properly. Check the cable and the hub. Otherwise, the server name or the host name of the SMTP server is
not set correctly. Use COMMAND CENTER and register the SMTP server name and the host name
correctly.
2204: The E-mail size exceeds the acceptable send data capacity. Decrease the size or resolution of the scanned data to be transmitted and resend the E-mail. 5101, 5102, 5103, 5104, 7102, 720f:
Turn the main power switch off and back on. If this error occurs several times, make a note of the displayed error code and contact your service representative.(Refer to the corrective action for the error message " An error has occurred.")
9181: The scanned original exceeds the acceptable number of pages of 999. Send the ecess pages separately.
Hope this is helpful,
Shawn
2101, 2102, 2201, 2202, 2203, 3101:
The network cable is disconnected or the hub that it is connected to is not operating properly. Check the cable and the hub. Otherwise, the server name or the host name of the SMTP server is not set correctly. Use COMMAND CENTER and register the SMTP server name and the host name correctly.
The link below takes you to Kyocera's Scan to SMB setup guide on GFBM's website (they are a Kyocera dealer). The guide setup guide is good and gives pictures and examples.
http://gfbm.net/Documents/self_help/SCAN%20TO%20SMB%20PC%20setup%20R3.pdf
I hope this is helpful,
Shawn
42,317 views
Usually answered in minutes!
I have a Kyocera KM-1820,
I know it is nice to give the Product im working with..
Thanks.
I have similar problem on Kyocera KM4050. The solution mentioned for JIMMIE839 has already been during configuration and even then the problem persist. Please suggest some other solutions if you have.
Its just a network issue. Try pinging the printer's IP address you will see that there will no respond from the printer.
go on the login page of the mfp and put the gateway, the effective gateway in tcp/ip section.
i have the same problem and with this i resolved
×