Hi, i need Dewalt DW005 motor power in amps, i have to use 24v transformer, please help and thanks

if the units transformer is not big enough, i would use a relay powered by the fan (G) terminal to switch the power from the 40va transformer you have.assuming you want the iWave to run when the fan is on?
if the unit transformer has the capacity, then wire it to the G and common terminals on the furnace.
if you are not trying to power the iWave only when the fan is running let me know what you want it to do.

Hi aqhnc,
You need to change the whole power supply unit. Your transformer inside it might broken and need to fix.

I hope my solution may help you.
Thanks for using Fixya...;-)

http://service.dewalt.co.uk/Products/ProductDetail.aspx?ProductID=5841

Hi,
Transformer is already toasted...
Replace it and install a 5 amp fuse in the 24v side...this will protect the new transformer.
Then find out where the 24v side is shorted at. may be a bad relay or a bare wire..

heatman101

Sounds like the circuit board is a good suspect.
Sometimes a resoldering of compoment leads will fix things.
You can also replace the circuit traces with individual wires

Sounds like you have already done a good trouble shoot, so I hope this info helps you get back in action

Check fuses inside. Check fuse and connections in plug. If this is a 110v radio there is one on transformer winding.

The battery has probably lost it's ability to receive a charge. Is it old? Check the output of charger, should be around 26 volts DC at the output jack.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Hi, You should take it back while the warranty is still fully intact as this is a problem and will not resolve itself.
Good Luck to you, this should Fixya!

You will need he correct charger, the 24V will destry a very expensive battery.