Canon pc-6re error code EO 10

You can have this Error Code resolved, I am just not sure that it would be wise. These are the facts. You have a 10 year old machine which has an EO error code which means there is a problem with the Fusing Unit. The parts required to fix the error code are anywhere from $150.00 to $250.00 depending on if you go with the whole fusing unit or just the Fixing Film Assembly which is going to contain the defective part(s). There is some dis-assembly of the machine required in order to replace the parts. If you hire someone to do this you are looking at another $100 to $200 in labor depending on who you call. So you could easily spend $250 to $450 to repair the problem. These type of small copiers are sold brand new at Office Depot and other stores now days for $100.00. They will also have a USB port so you can hook it to a PC and use it as a printer. I am in the repair business and have been for 27 years. I would not recommend that any of my customers make a repair to this machine of this magnitude. I have in fact referred 2 of them in the last 5 months to go buy the new Canon D340 instead of repairing the old one.
Good Luck to you and Thank You for using Fixya.
WheatlandServices

Odds are that you are getting a error code E000. It is saying that you have a problem with your fuser unit. You can try to unplug the copier for a short time. But you will mostly need a new fuser unit. Good Luck

Use a thin but strong piece of card board (such as the back of a standard yellow pad notebook) and easily force feed it through machine. I had to use this method with our Canon Pixma MP190 printer. Hope this helps, Good luck!!

You'll have difficulty finding that one, but really..... what is there you need to know?...it's as basic a machine as there ever was.

Then Error code means that the fuser / fixing Lamp is blown or it could be the thirmal fuse is blown. It could also a bad thirmister, that may have caused the fuse to blow. One thing you can look at, will the fixing unit get warm or hot. Do you know any copier techs, as a friend. It is not a easy job to fix this problem. You have to fix it to clear it.... Good Luck

i think the problems is in the delivery roll,the rubber is need to be change with the new one

tthis is really old 25 years plus. replaced the drun cartridge which also contains the toner good luck canon sr tech

hi do this to reset the fuser unit:
go to service level one by pressing  *28* then copier --function--clear--error-ok
if that doesnot work either replace  thermistor
Best regards

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

hi im jules_09,no the copier is not dirty or jammed,if there is a paper jam it will indicate paper jam there is no error code for that,if the copier is dirty you can see it in the print.reset the error code in the program,if the error code is still there checkfusing unit then the optic sensor

Go to the "Add and Remove Programs" in your Control panel.
Do a "Change" and do the 'repair program' utility.
That should fix it, good as new.
If that is not a possible option, try uninstalling. (if there is no "Change" and 'repair program') then Run the normal uninstall program.