Kyocera FS 1000 - paper wrapped round hot roller

You cant find the reset because there is not one. OKI do not use resets to cure errors. Yes a 980 is paper wrapped around the hot or pressure rollers in the fuser. Normally you just take out the fuser and remove the paper and it will start working. However this MUST be done with the power OFF. So it should be a case of just turning it off and removing the jam and refitting the fuser and turning it back on. If the error is still there then alas a new fuser is require to get it going again. You may be able to buy a fuse from suppliers on the net, fit it and that will do the reset without the need of buying a fuser.

can you do a test page. how's that look?

Sir/Mam there is cleaning motor for one of the rollers in the fusing unit the very hot part on the right side of the machine is there anything like a transprancies or paper wrapped around the fusing unit roller. Recommended that you get a tech out to look at it remove the fusing unit and look it over. Do not use the machine you burn out that motor it will cost more to repair worse case you burn out the main control board 1000 dollars. Motor is inside the machine

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Your heater roller is not working

more than likely to be paper wrapped round the hot roller - remove the fuser and split it - then clean the thermistors - should sort it

The red rollers are probably replaceable, and therefore removable. Take a close look, and see if you can tell how they would be removed. It will either snap out, or you'll push it to the side and remove one end at a time. It'll be easier to pull the paper without the roller in the way.
While you have the roller out, you can clean it by wrapping packing tape around it a few times.

clean the paper feed roller with a damp cloth after removing the paper tray, otherwise call a technician since parts may need to be replaced, including the roller in case.

first try cleaning the charge roller on the drum unit or check the hot roller on the fuser

Hi

Unplugged and try to access inside of the printer, be extra careful because you might damge the sensors. If its hard to get the film around. have it service instead.

Hope this helps

replace pick up rollers and paper tray roller. Take out paper tray and toner, lift printer so you can see underneath you should see a set of rollers its nopt to hard to get out. also in the paper tray there is a roller swop that out to