In the past the option blinks and then it was stable and not visible but can be chosen.
SOURCE: Mitsubishi WD52525 DLP Projection TV
Mitsubishi TV troubleshooting
Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold down the Device and Menu buttons together for about 5 seconds.
The Power light will start to flash in a two digit sequence.
For example, 3 flashes, then 7 flashes = 37.
Here are the error codes, and the corresponding problem:
12 = No error detected, check power supply.
32 = Lamp Cover is open.
33 = Air filter cover is open.
34 = Lamp abnormality
36 = Light Engine (DMD or Lamp Fan stopped)
37 = Exhaust or Lamp Ballast Fan stopped
38 = Lamp Temperature High
39 = DMD Temperature High
41 = Short is detected
44 = DVI cable between FMT and Engine disconnected
SOURCE: Philips 32PW4523 with no widescreen options
no way to recover that info without obtaining a good service manual that has the default info loaded. Thats why you should always write evrything down that you change in the service menu and never change anything without having the service manual so you will know what the items sre what your adjusting. I can post a link where you can get a good service manual if you would like.
SOURCE: Autoconvergence option is GONE!
There is a blown fuse and diode located next to the flyback transformer I believe the location is DL231 and the fuse is FL231
SOURCE: The convergence on this television has obviously
This RCA tv model use a convergence fuse.The covergence fuse FL231 is dead.U have soldering iron,u can do basic soldering?Try Ebay.com to buy the convergence fuse for the replacement.This FL321 have three fuses,the one in the middle is dead.The FBT,the big black block of plastic,resolder that too.
567 views
Usually answered in minutes!
convergences fuse is good the only thing unusual is a whistle when the TV is off
My tv is a RCA Model D52W20 Serial E246C10AQJ not see any burnt piece esplotada on board.
My tv is a RCA Model D52W20 Serial E246C10AQJ not see any burnt piece esplotada on board.
I checked all the welds and can not find any other damages of any recomendasion the check too.
×