At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Saftey circuit issue! check clutch switch, side stand switch and wiring these are connect to the neutral light switch and the 3 are part of the saftey circuit, circuit is designed to cut the bike out if the stand is down and you kick it in gear also to stop the bike turning over & jumping forward when you hit the starter and its in gear and the clutch isnt pulled in.
weak stand spring my not be pulling stand onto the stand switch correctly there fore no making the curcuit, switches just make and break the curcuit.
I would say you have problem in the tank with the fuel pump line. When you lean the bike on the kickstand all the fuel goes to the left side an covers the line which then creates enough fuel pressure to run the bike. If you filled the tank full it would probably run ok until the fuel level gets below the bad line.
ideally leave it for 24 hours(but it wont hurt if you switch it on staight away)the standing time is to allow any air(gas) in the system to rise to the top of the pipes.besides it gives you time to check and level the doors,so that the seals fit flat all round.dont forget to cover/wrap all food in the fridge to cut down on condensation.root veg is best kept in airtight bags.
remove grill and approximately 6 to 8 screws hold speaker to box. Follow appropiate wiring in removal as replacement. Check crossover while you have it appart
These digital amps are very prone to blow if the speaker wires are shorted so Sony appear to have put in a protection system that mutes the amp when this happens. You have to unplug the amp for a minute till the light goes off, make sure no speaker wires are touching each other and then it should work ok. I found the same problem with one I bought 2nd hand.
×