How to solution of FUSER TEMP. - Ricoh Aficio Sp 1000sf All-In-One Laser Printer

The error code is related to the fuser area.

Likely to be a low fuser temp issue.


Need to verify good or bad heat lamps.

1) Check each lamp in fuser.

(lamp is good if you get continuity)
(lamp is bad if open)

2) Check the thermostat. (thermal control device)
(triggers if unit gets too hot)

3) Also check thermistor (monitors temp of fuser)
(2) total (middle and rear)

If heat lamp is good:

Your best bet is to change all three items. (Temp fix)

Fuser thermostat - thermal control device
Fuser thermistor (middle front) - thermal control device
Fuser thermistor (rear) - thermal control device

These items wear out. Change at the same time.

Fuser needs to be rebuilt or replaced.

You need to have the Fuser replaced

SISODIYA COMPUTERS "I AM SOLVE THE PROBLEM FUSER TEMP ERROR "
BUTTON FAST PRESS STEP BY STEP
LET'S START
PREES- MENU BUTTON
* BUTTON(THIS IS STAR BUTTON)
# BUTTON
1 BUTTON
OK BUTTON
STOP BUTTON
MENU BUTTON
# BUTTON
^ BUTTON(THIS UP ARROW BUTTON)
OK BUTTON
YOU LAST BUTTON PRESS OK AND POWER "OFF" AND WAIT UNTIL 15 MINUTE AND PRINTER START PROMBLEM IS SOLVE FUSER TEMP

You will have to replace the fuser. Call 1-800-835-6100 and follow the prompts to purchase parts. It isnt real expensive. Just make sure you still don't have some warranty left on the parts.

fuser Temp printer error problem.please give me the solution.

please your copier fuser thermostator is displace or over dust toner clean it and solve your problem

It is giving me an error message of "printer error,fuser temp"

U4-2 Low fuser temp problem U4-3 High fuser temp problem U4-4 High fuser temp problem U4-6 High fuser temp problem

replace thermistor in fuser unit

"E000" Low fuser temp. (Heat lamp, thermoswitch, thermistor, SSR) "E001" High fuser temp. (Thermistor) "E002" Fuser temp. too low "E003" Fuser temp. too low "E004" SSR, Fuser temp too highchange thermistor in fuser

Hello,


The error code is related to the fuser area.

Likely to be a low fuser temp issue.


Need to verify good or bad heat lamps.

1) Check each lamp in fuser.

(lamp is good if you get continuity)
(lamp is bad if open)

2) Check the thermostat. (thermal control device)
(triggers if unit gets too hot)

3) Also check thermistor (monitors temp of fuser)
(2) total (middle and rear)

If heat lamp is good:

Your best bet is to change all three items. (Temp fix)

Fuser thermostat - thermal control device
Fuser thermistor (middle front) - thermal control device
Fuser thermistor (rear) - thermal control device

These items wear out. Change at the same time.

Fuser needs to be rebuilt or replaced.
(Check for wear and tear)


Inexpensive repair for the temp fix.

The whole Fuser cost can brake the bank.


I buy parts from precisionroller .com (you can preview the parts)



Franklin
baselinerepair .com