Opening cabinate? Admiral washer AAV 7000 AWW

washer: check clutch assembly links with instructions here https://www.youtube.com/watch?v=tVc6SZ2DD4U

dryer: check support weels (2) for a flat spot or if theyre hard to turn

Robert, i'm sorry to say but the AAV's are machined parts and the seal should not have been broken by removing the cap. The floats are set perfectly and you would have been easier replacing the whole vent. You could have isolated all the pipes under the boiler and just drained the boiler down by releasing any pressure by the pressure release valve. You may need to buy another AAV and start again.

it sounds terminal

Hi bgpace02669..

To to this webpage to see a picture of how to route your belt.
Please take time to rate me

http://www.expertappliance.com/dryerbeltconfiguration.html

The washer was made from 2000 to 2001

Open the control console.
Use a voltmeter to test the timer motor.
Set the machine to wash.
Place the meter leads on the 2 timer motor wires.
If you read 120 volts and the timer does not advance,the timer motor is bad.
The complete timer will need replacing.

You may have a broken gear but I do not advise opening any part of a computerized machine, you will need a specialist otherwise you could blow the computer boards with static

You cannot use a cheater, studdor or mechanical vent or an AAV on any Saniflo product. As they are considered one way vents, they only allow air to flow one way. Saniflo pumps must have an 1 1/2" vent pipe vented to the open air, air must flow in and out of the vent pipe at all times, otherwise the pump will short cycle and the solids will not leave the toilet. You will have to flush it several times to get rid of the waste and eventually the motor will go bad. Make sure is vented properly.

try moving the cloths around to balnce the load

Hi, the drain pump impeller is damaged. you will need to replace the entire pump(drain) in this case.

You will hear this noise when the impeller become separated from the actual drive stud or, shaft.