The Delay button is blinking and I can't get the washer to proceed with cycle. I pressed cancel (unlock) button so that I could check some contents and now I can't get the load to continue. I would like to either cancel and start over or continue but I can't get the machine to start again.
I also had this problem, i switched the machine setting to drain, then it cancelled the delay, and i was able to reset
Usually pressing PAUSE/CANCEL twice cancels the cycle and shuts it off allowing you to then re-start the cycle. If not try unplugging it and see if it resets to allow you to start cycle again.
I appreciate your post, friend!
I understand that the clean, wash, and dry buttons on your Frigidaire dishwasher are blinking along with the four LED light. This appears to be a delay start cycle. I would recommend pressing the cancel button. If that does not clear the lights you can perform a reset and to do that you would need to disconnect power from the dishwasher for roughly ten minutes. I hope this is helpful. -Matt
1,339 views
Usually answered in minutes!
×