The printer Ar-5516 is showing H4 error - Sharp AR-5316 Advanced Digital Imager Copier

6ya staff

• 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

Leroy Elliott

• 3085 Answers

SOURCE: Ar 5516 display H4 error

H means heat, you need a new fuser.

Posted on Mar 28, 2010

SOURCE: SHARP AR 5316 error H4

The problem is in the fusing unit try these steps:

STEP1: Press continuously CLEAR then INTERRUPT then ZERO then INTERRUPT

STEP2: The panel display will turn off it means that you are inside the simulation if not repeat again step1.

STEP3.Then type 14 then press the print button

If these steps doesn't work you must call an authorized serviceman to check your machine, maybe something is busted on the fusing unit like thermostat or fusing lamp.

Posted on Mar 01, 2009

SOURCE: sharp ar 5516 printers error h5. h4

hi,I have error code L h on my coppier sharp 5516. your help please.

Posted on Aug 25, 2010

SOURCE: Sharp AR-M450 is showing error code ''H4-00''

You're getting a heat roller low temp detection on the fuser in your copier. The fuser is the device that provides heat and pressure to the toner to bond/fuse it to the paper (it's that black, rectangular box in the upper part of the body when you open the left-hand side of the door).

Chances are a peice of paper is jammed up inside and blocking the sensor (probably a small peice that tore from a page someone tried to pull from the fuser). That or the temp sensor is defective.

Posted on Aug 21, 2009

SOURCE: Ar 5516 display H4 error

This means that the fusing unit has a problem. Turn off the copier. Open the small side cover on the right of the fuser unit. You will see the wire connectors leading from the unit and carefully remove them.Open the three screws holding the unit and remove it, check the heater lamp continuity if out replace the lamp. Clean the thermistor and return the unit by reversing the removing process. Now try the code and it will work.

Posted on Mar 30, 2010