WHY DOES MY TECHNIC 1200 MK3 GO IN REVERSE IF I HIT THE START BUTTON TWICE?

Most likely drain Pump problem. Either obstructed or defective

There is a very sensitive adjustment to be made. Dealer work.

reset the panel by hitting normal-- heat dry NOT at the same time until all lights flash then push cancel and it should start.

Press 'setup' key for 11s not 'learn' key.

its an error. hold down the power button till it beeps once. the hold it again till it beeps twice. The moment it beeps twice take your finger off and instantly hold it down again. your ps3 with give you 5 onscreen options, hit #3 and only number 3. that should fix the problem. You can also youtube "how to fix disk error on ps3" and people will should you how to do these stated steps.

Press and hold the button until it flashes.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

Hold down the tv and power button until it turns red
Then press play once the light will blink once it stops if the t.v. has not turned on press again then continue until the tv turns on.
Press reverse until tv turns off
Hold down stop until light goes off

On the garage opener that actually opens the door the one on the ceilling has a green or orange button that is called the learn button just press and release it you have 30 seconds to punch in a 4 digit code and when your done press and hold the enter button until the lights on the garage open blink once or twice then just press the code again and it will open the door press enter once to reverse the effect and and twice to stop the door completely.


Hope that helps

What model machine are we talking about here? If it is a Designer 1, Reverse doesn't show up on the screen. You need to hit the Reverse button twice in succession, the button stays lit up, and the machine should sew in reverse until you hit Reverse again or change stitch.

When a reverse arrow shows on the screen, it is usually when a programmable stitch is selected and you need to hit Reverse to complete the programmed task.

Get back with more detail on your machine and the problem, and maybe I can offer some more specific help.
Pamsquilt

f1 is the code for primary control failure cod be a bad connection at the primary control under the control console or a faulty primary control if its still under warranty id have a tech look at it