Can't record a DVD

SOURCE: DVD player recorder won't read or play any disc

This just worked for me. Don't know how long it will last though. I found it on this webpage
http://forum.ecoustics.com/bbs/messages/15118/130292.html

To do a reset:
On the remote control press the SETUP button,
Press the right key on the remote 3 times,
The Preference page will show up,
Press the down arrow five time to highlight
"default", hit right arrow to highlight "reset"
Press enter to reset. Turn off/on machine, etc.

SOURCE: CAN'T READ DVD ON OTHER DVD PLAYER OR COMPUTER

I have since learned about finalizing it and it works just fine. Maybe Insignia isn't total junk.

SOURCE: How do I record my vhs tapes to Disk

I have done a lot of dubbing on my machine. First make sure the DVD is formatted. When you put in a new disc it should ask you if you want to initialize. Once that is done, switch to VCR mode. push play on the VCR then push the DUB button on the front of the machine. I hope it helps.

Rod

• 224 Answers
• Posted on May 01, 2009

SOURCE: want to burn some movies off my dvr

http://www.usersmanualguide.com/

see if theres a manual here

SOURCE: I cannot get my Insignia combo player to play some

You may need to have you unit checked out for aging of the laser, or some weakening of the units drive circuits. You can call Insignia Technical Support at this number : 1-877-467-4289. You can also try cleaning the laser head with Isopropyl alcohol and a cotton swab. Gently try cleaning the laser by rubbing the cotton swab with very little alcohol until the head seems clean and shines. Do not use too much pressure or you may damage the alignment of the laser. Also used a can of compressed air to blow clean any excess dust and debris in the drive carriage. Hope this helps you with your problem.