Error code f35 on my washer

SOURCE: My Kenmore Elite he5t steam washer gets F35 error code

F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.

If you remove the top panel, three screws in the back, you will have access to the pressure switch.

With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.

If the fault codes return after doing this, you will likely need to replace the pressure switch.


Also - please be sure to use He soap.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.@#$%

SOURCE: Whirlpool duet front load washer flashes F35 shortly after start

Sud= The unit has sensed there is too many suds in the unit it will flush and pump out for 5 min and restart on its own..This is caused by too much soap use..
From the book :
SUD Code=
If too much detergent was used:
—Run the unit through a Rinse/Spin cycle.
—Run a Normal cycle without adding any detergent.
This should clear the unit of the excess detergent.
1. Check the drain hose and make sure it is not plugged
or kinked.
2. Unplug washer or disconnect power.
3. Check wire harness connections to the drain pump,
pressure switch, and Central Control Unit (CCU).
4. Check/clean drain pump filter of foreign objects.
5. Plug in washer or reconnect power.
6. Check drain pump.
7. Check the pressure switch.
8. Verify CCU operation by running a Diagnostic test or any
cycle.

Starnley Johnwells

• 1031 Answers
• Posted on Aug 21, 2009

SOURCE: I get F35 error code on my duet washer

Both of these fault codes point to a pressure switch issue. If you remove the top panel, three screws in the back, you will have access to the pressure switch. With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions. If the fault codes return after diong this, you will likely need to replace the pressure switch.

SOURCE: Kenmore Elite HE5t Error Code F35

Very easy to replace the sensor...hard to swallow that the $.05 of plastic that cost over $100 plus shipping. I did google sears parts discount code and found a free one that knocked $10 off the total. I also complained @ CPSC's Hotline at (800) 638-2772. It is nothing in my operation that made this part malfunction, the fact that Sears Parts had it backordered and no official parts dealers within 100 miles had the part on hand ought to tell them that this should be recalled! We are 4 loads in and praying that it keeps working, after spending over $100 at the laundry mat for our family of 6 I am still fuming that I stayed with Kenmore (last washer lasted over a decade) and they suckered me into a $2,000 investment in their washer/dryer system. I did take the front bottom panel off and clean the filter, pretty nasty but easy to do as well. Thanks for the help, I was determined not to pay Sears anymore than I had to.

SOURCE: model: wfw9500tw01 f35 error

F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.

If you remove the top panel, three screws in the back, you will have access to the pressure switch.

With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.

If the fault codes return after doing this, you will likely need to replace the pressure switch.


Also - please be sure to use He soap.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.