Dryer stopped working

The circuit panel could be at fault

First, remove the top and see if the belt is really lose.

Broken dryer drive belt

with no light it tells me you have lost L1 check your outlet, and your wire connections
'

if the machine is completly dead an not doing anything locate your fuse panel ,check your fuses for the dryer ,if you can find wich one is it reset the breakers again you probably popped one of the 2 lines since you need 2 for a 220v.

good luck!

Unplug your dryer for ten min. This will reset the circuit board and reboot the system. Sometime small power surges can disrupt the curcuit and cause the unit to get confused. Rebooting usually will fix this type of problem with surges.

Inside the drum is 2 long metal trips that measure capacitance in the clothes as they get dryer. Sometimmes liquid fabric softener gets on them and stops the process. Wipe them off. They are right on the filter housing inside just below the filter.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Your dryer doesnt have a fuse. Your home breaker panel is the only protection it has..Check your circuit breaker box for a tripped breaker.

more than likely a thermal fuse has blown ..i believe on that model you pop the clips holding top down element is on rear wall of dryer thermal fuse has 2 white wires going to it and is mounted on side of element the big thermostat on top and the fuse come in a kit and should be changed together

hi .thanks for the question. if its the timed dry cycle that s not working .replace the timer .thanks the appliance doc