POWER SUPPLY HEY MAN I WOULD LIKE TO KNOW WHERE I CAN PURCHASE A POWER SUPPLY BOARD

Try disconnecting from power supply for a few minutes,then reconnect power supply.

Hi' for the power supply 'purchase 600 watts and with 24 pins sockets 1-2gb RAM is quite enough

Hey,

The power supply board is dead, u know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

I hope this will help in solving the problem.....

Hi,
Power supply board part number for Sony KDF-E50A10 is as follows:
A1113732A .... GT BOARD COMPLETE
and if you are asking for ballast power supply board part number, it is as under:
146893611 ... POWER SUPPLY BLOCK
Hope these info will help you.
Thanks.

You can purchase a power supply board for HP laptops from the below link:

http://www.partshere.com/online/detail.asp?partno=0950-2417

If we can know the part number of your HP computer, you can find the exact Power Supply board for your computer model.

You can find the part number of your computer from the below link:

http://partsurfer.hp.com/cgi-bin/spi/main?jumpid=reg_R1002_USEN

You can find it even from HP parts store.

Have you test the power supply for voltage, Is it good, if it is then the problem of course is not power supply. Some power supplies have a light on them. Also does the power supply fan work, If not almost always sure sign power supply is gone. Old power supplies are still available Every time I junk a computer P4 or older I save to power supply, What wattage?

You can contact the manufacture to purchase the power supply module.

However, there are other boards in the set that can easily cause the power supply failure because something went defective. It is also possible that the power supply is not defective, but it is in protect mode because of a failure on another board, or in some other device in the set.

The tech would follow procedure from the service manual using the proper instrumentation and diagnostics to determine the defective board(s). Then he would replace the necessary modules and or parts to get the set working again.

In the end if you try fixing this yourself, you can end up spending a few hundred dollars on a power supply and only find that it blows again or goes in to protect mode because the original fault was not determined and corrected.


Jerry G.

Just change the board unless its just a fuse that is blown

Hello,

The Power Supply for LTV-32W1 is listed below.

Westinghouse LTV-32W1 Replacement Power Supply Board

Glad to hear man! Thanks for the follow-up.