Power out the power will not come on the power will go in to mei filter but will not not go any further

See the fuses and the input stage where there is a filter and a varistor. Check the rectifiers and the power supply. This is a switching power supply. You might want to secure a schematic before you do the troubleshooting.

You made a mistake, you lost your password. Learn from this, whenever you create a new password write it down where you can find it when you need to.

Remove the trans pan,clean,replace filter if you want too,
& refill

I do not suggest you try & flush todays electronic trans

Not what you hear, but your better to warm it up or drive a day
or more & change again, if your a perfectionist like me

I will tell you personally & having owned a trans shop, if you
don't change the fluid in the trans, as well as power steering,
every 3 years ,you will have major expensive repairs down
the road.

The backlight circuits are not working, check the DC filter caps in the power supply first, look for caps with leaking/bulging tops. Check to see if you do have 12~18vdc feeding the inverter circuits.
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, blown fuses; poor solder joints, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://en.wikipedia.org/wiki/Capacitor_plague
http://www.badcaps.net

Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, blown fuses, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://en.wikipedia.org/wiki/Capacitor_plague
http://www.badcaps.net

Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://www.badcaps.net
http://en.wikipedia.org/wiki/Capacitor_plague

You need to open it up nad inspect the caps, look for caps with bulging top or seal, post back what you find so we can guide you further, see example of failed monitors due to bad caps: http://s807.photobucket.com/home/budm/allalbums

co1 error

well i want to tell u that is a very common scenario u just replace the fuse and sometimes due to power low and high the fuse gets blown and u might also wanna check ur power chord.

Is there power coming out of the mei filter to the board?