Frigadidaire refrigerator control panel not working

IF YOU HAVE ALOT OF FROST ON THE BACK PANEL OF THE FREEZER IT IS A DEFROST T-STAT THAT CAN BE BAD IF THERE IS NO FROST FELL UP IN THE LEFT UPPER CORN OF THE FRIG SIDE SEE IF YOU CAN FILL THE AIR COMING OUT OF IT

Its not even a refrigerator you dumb egyptian ****.. SOME ONE SOLD YOU A REFIGERATOR BOX~!!!

if you mean the compressor isn't running most likely you have a bad start device part 67005560,pull out machine unplug it and remove the bottom back panel,look at compressor,pop off metal clip and remove cover on the side of compressor,slide off the device and shake it,if the device is cooked you'll hear pieces rattling around inside it,install new part,if it still doesn't start could have a bad compressor.

Check your fan on the back of refrigerator...Might need replacing..Surly needs cleaning

More than likely the user interface board that controls that portion of the machine is probably bad, or, worse case scenario the main control board which has the overall say so for the machine has gone out which isn't uncommon either. My best advice is if your going to do it yourself buy your parts from www.repairclinic.com because of their return policy which you can return any part you bought even if installed/

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

well if the foot pedal isn't working, you can either replace it with a new one or take the machine to a sewing machine repair shop & let them check the foot pedal & see if it's fixable

If you follow the positive cable (right at the post in most cases) there is a 50 amp fuse. You may have blown that fuse whicgh is common when changing the battery unless you remove it. Connecting the positive cable first when installing the battery helps prevent this. Also there are several other fuses that you may have blown which connect to the theft system going to the body control module which will prevent the vehicle from stating. If the fuse on the posive cable isn't blown (which I bet it is) in the fuse panel in the vehicle check fuse number 3, 4 , & 19 . See layout diagram below. Also in the fuse panel in the engine comapartment you can check fuse number J and 25 . See layout diagram below. I hope this helps and good luck.

http://www.gasrefrigeration.net/dom_techdata/26121_2852SM.PDF

Since this unit has no compressor and uses an ammonia mix and heat to cool, it isn't your standard household refrigerator. So be careful working around the coils.

The most common failure for your problem description is the thermoster followed closely by the lower control board. But we have also been finding more and more corrosion buildup on the terminals that is keeping the unit from functioning correctly. Suggest you ohm check the thermoster to see if it has opened. If that shows an open, then replace. If that doesn't work, then take the lower control board out and clean the terminals and connectors with a scouring pad following by the #2 pencil eraser cleaning of connectors. If that doesn't correct it, then replace the lower control board.

There are several ways in which you can increase the volume.

First, the most obvious way is to use the volume control attached to the speaker unit itself. If that isn't working, there's also an icon in the lower right-hand portion of the task bar in Windows. Simply click the ^ button, select the icon that looks like a speaker, then drag that up to your desired preference.

If that doesn't work, click on Start, go to Control Panel, click on Sound, then search for your Speakers in the "Playback" tab. First, make sure it's set as your Default Device. There should be a green check mark in it. Double click on those, select Levels, then make sure Play Control is set to maximum.
If that doesn't work, then check the settings on your Sound Card. Make sure the wire going into the back is plugged in properly. You may need to update your sound card drivers. If you aren't sure who the manufacturer of your sound card is, you can find out by going to Start > Control Panel > Device Manager. The Manufacturer will be under Sound, Video and Game Controllers.

Once you have that information, you can go to the Manufacturer's website and update the Drivers. If this doesn't resolve the issue you are experiencing, or if you require more specific / additional information, simply respond to this thread. I'll be happy to assist you further.
Regards,

Aaron Busch
Senior Tech of LiveFix Support Services (LiveFix.net)