What's your problem? Sylvania LC195SLX It will change chanels, change inputs, volume up and down, at any time it wants! The only thing it dont Do on its own is turn on or off

It is over 10 years old so would no longer be supported.

https://www.google.com/search?q=Sylvania+LC195SLX+firmware+update

..

Try 124 code, might work for combo unit.

Check if there are input on the audio connected.

Hello! This can be frustrating to watch!! To change the format on your DISH remote, all that you need to do is press the * button below the number 7 on the keypad. This will change the format for the TV so that you find the one that suits you best. The best that I have found is Zoom. I hope this help!


Becki Barned
DISH Network Customer Service
[email protected]

Hello! I hope that you have gotten this resolved, but if not, here are some steps to do so. You can program the remote to the TV first and then use that for this, or you can use the buttons on the TV itself.

Remote to TV Steps:

1. Hold down the clear TV button until all lights light up at the top of the remote
2. Punch in a 3 digit code (provided below)
3. Press the # (POUND) button
4. Try powering the tv on/off, and the volume. If one or more of these functions do not work, start over from step 1 with a different code
527
733
632



Satellite picture back:

If you are at TV1, where the receiver box is located, the tv needs to be on channel 3 or 4.
If you are using a coax cable, the TV needs to be on 3 or 4.
Depending on the cable that is running between the receiver and the tv, the tv may need to be on an input, such as video 1 or 2. If you are at the TV2 location, where there is no receiver, then the tv needs to be on channel 60 or 73.
If you are using an HDMI cable, then the TV will need to be on an HDMI input
If you are using Component cables, your TV will need to be on a component input. (Usually Comp 1 or 2)
If you are using RCA cables, then the TV will need to be on a VIDEO input (Usually Video 1 or 2)


Becki Barned
DISH Network Customer Service
[email protected]

Recheck all connections and try to get the TV on channel 3 or 4 especially if you have a cable or satellite box.

Here is the manual you are looking for http://tv.manualsonline.com/manuals/mfg/osram_sylvania/lc195slx.html ... hope this helps

The power supply is down . Sylvania power is very simple went you take the back off you should see the two bad capsitators on the board.Just replace them with same value .

It looks like your TV doesn't have a digital tuner in it. Without that you won't be able to receive any broadcast television stations. The spec sheet is here: LC195SLX the tuner is listed as just ATSC/NTSC - not digital. You will need a cable or satellite box to receive stations.