Lid light flashes even after power button is turned off
Lid switch was flashing on/off now won't even light washer fill and pumps out but won't wash or spin HELP
Possible that the switch is defective, there is fault in the line to the control unit from the switch of the control unit is faulty.
check these one by one.
SOURCE: Cabrio washer want start.
leave the door open and try it again if it does the same thing as before the door lock has gone
SOURCE: where is the reset button on Cabrio dryer
there is no reset, unplug the unit for 5 minutes, if it still won't start you have a CCU problem, that is the central control board.
Testimonial: "Hey there- Thank you so much for your help. I think I have a central contol board problem. I will have the repair man out tomorrow. Denise"
SOURCE: door locked, won't turn on. won't reset
Remove the bottom panel which would give you access to the pump area if you look up along the side that the door lock is on you will see a cord with a loop on it pull this cord and the door would open. The panel must be removed in order to locate this pull cord. If you have any further questions message me back and please also remember when our chat has fully concluded to rank how this opinion has helped in your appliance situation it allows me to continue helping others in similar situations in the future Thanks Rick
p.s if after you open the door and you were to leave the unit unplugged for 7 minutes if the error did not go away or if the door once again locked up you would have no choice but to replace the door lock assembly on the unit Thanks again Rick
Testimonial: "Good advice fast! Thank you so much for your time and expertise!"
SOURCE: Will start the wash cycle and DL come on and light
Hi,
"dl"indicates a door lock error. A Door Lock Error occurs if the door cannot be unlocked. It will try to lock it 6 times before displaying the error.
Check for the following when dl occurs:
Thank you !!
4,045 views
Usually answered in minutes!
Power button won't work
×