What does the sensing light mean - Whirlpool Cabrio 7.0 Cu. Ft. Super Capacity Plus Gas Dryer

I am not sure I understand what you have going on here, do you mean the security light is on but the car starts? If so then there is a fault in the security system sensors or wiring and when that happens the light doesn't mean the system is armed it means it is sensing a fault..

It means the Traction control safety system has turned itself off due to a failure sensed by the control module. You must now have it tested by the dealer.

Good afternoon Amanda

There is a 'Dusk to Dawn' mode in these lights in which it will turn on continuously for 6 hours once it senses dusk, and then go back to the automated sensing mode for the rest of the night. This is triggered by turning power on and off twice within three seconds. See the manual here (
Defiant MST18920lwdf Use And Care Manual Feature Selection Troubleshooting )

If you follow this link, there is a forum with the same question and a walk-through of how to toggle the switch for manual mode.
how do activate manual mode to keep light on longer on LED Motion security...

That should get you off to the races. Good Luck!

may mean u have a moister sensor issue

its normal for the new washers to sense how or what type of load you put in it , first thing after start is pressed , if it stays in sense! then it has detected a fault , either the sensor or the load is at fault , try the manual setting and see what it does

It means the emergency brake is on or slightly depressed. Try wiggling it to see if light flickers. Or you are low on fluid, or have a leak and it's sensing the pressure loss.

A service engine light means it's time for an oil change. That light needs reset after the oil is changed. The computer senses the miles drove automatically and says "change my oil, it's been 3,000 miles" A CHECK engine light means it has to get a scan done. Change the oil, it will be fine. It is suppose to do that. Let me know if this helps you.

Hi, the code P1782 means that 2-4 pressure switch sense circuit FAILURE. It basically means that the transmission solenoid pack needs to be replaced.

The code P1782 MEANS 2-4 pressure switch sense circuit FAILURE. Basically means that the transmission solenoid pack needs to be replaced. Not a hard job

my whirlpool 6th sense will not start all lights and power i think that it is the door sensor at fault? The green light door locked light is not on.