SOURCE: mitsubishi wd-52628 flashing green timer light
If the power/timer led is the one blinking constantly
the most likely problem is two 3300 mfd caps and 1 to 8 1000mfd caps on the power board.
could be the DM board or caps on it as well.
SOURCE: RED LAMP LIGHT!!
Check to make sure your lamp is not blown.
Make sure you installed a Mits original, and not a generic.
Make sure the lamp is seated and secured properly, as slight movement can cause a loss of connection.
Slide your set out to the side and peer into it through the slats. Can you see the lamp fire on?
Your symptom does not indicate that it could be a problem other than the lamp and the installation thereof, however---there is an instance where 2 capacitors will blow on the power supply and cause a red lamp light to show. Furthermore, the light engine itself could be causing the problems.
But, since you just installed the lamp, I would look over your installation.
SOURCE: Mitsubishi WD-52525
The lamps can burn out if you suddenly lose power (and the lamp does not cool via fan). This can cause lamp failures and possibly other failures. Also, if the fan cannot get air sufficiently (from the filter (on the back of the set) this can cause thermal overload and other thermal failures. Be sure all cooling fans (yes fans) are functioning and free of dirt.
SOURCE: I HAVE A 65 INCH MITSUBISHI TV WD-62531, WAS
Have a Mitsubishi 65 rear projection menu keeps fading on and off, any ideas of the problem. Bulb just replaced 2 months ago, no problems with bulb. Also a DVD works fine, but tv picture will not come on.
104 views
Usually answered in minutes!
×