SHOW ME THE FUSER - Office Equipment & Supplies

there is nothing to look for it told you it is past the end of it's life so buy a new unit

This is a fuser or heater code. need to test the thermofuse that is in the fuser. If you can see the fuser when you turn on there should be a lite on, if not no heat and machine will show that code. Possible need fuser t or thermo fuse replacement . Good Luck Remember if fuser is on it is very Hot do not touch with fingers...

To reset fuser unit you need change the 60mA/250V fuse,located in the fuser unit contact house (a little green diode).

It's best to remove the fuser to get access to it. This video will show you how to remove it, and which levers to move to release tension in the pinch roller to clear the jam http://www.youtube.com/watch?v=UjyggtF8d1k After you remove the jam make sure to do a close inspection on the internal roller (use a flashlight). You're looking for any scratches or "dents" in the colored roller (sometimes a deep red/brown color sometimes blue) if there are scratches you are probably going to have to replace the fuser. The imperfections on the fuser roller will show up on your printed pages. If you do need a new fuser you can find them for $160, or the entire rebuild maintenance kit for $375 http://www.fastprinters.com/productdetails.asp?PRODUCT_ID=DELL-UG190

Fuser faulty, replace it..

Pull down the rear door. There should be 2 screws on either side.....remove them....look for 2 more screws towards the bottom. Remove them....the entire rear plastic of the machine should pull off...exposing the fuser. Remove the screws holding the fuser in place. Pull the connectors from the power supply below and you should be able to pull the fuser out! If you need a fuser you can get one at www.getthatpart.com they have good used fusers at good prices....you can also call them at 410-374-1261

wheb i give the print out, just show error 50.2 fuser error,
pls give me solution what may problems

Just solved the same problem. Mine was the fuser. It is either the drums or the fuser. Print something with color then turn machine off before it hits the fuser. If toner does not show up running before it hits the fuser. Then you fuser is bad~$100.00. If the toner runs before it hits the fuser then the drums are the culprit. If the fuser is bad, it will not heat the toner enough for it to stick to the paper then the unfused toner gets on the roller of the fuser and repeats the image or part of it in equal increments down the page.

You need to replace the fuser, here is an example of replacement part
HP Fuser for LaserJet 5000
These are instructions for replacement:
HP laserjet 5000 fuser instructions