T6524 Desktop will not come on

shut down your computer and remove the side cover and remove the memory from the slot and switch on the computer if you hear beeps switch down the computer and insert the memory if you still hear beeps means the tre is an memory failure you need to change the memory while removing memory you didnt hear any beep it means there is problem with your motherboard remove the processor heat sink and the processor clean the surface then insert the processor to the slot apply a thin level of heatsink compound and fix the heat sink then switch on the computer

Please check following KB article:

Advanced troubleshooting for shutdown problems in Windows XP
http://support.microsoft.com/kb/308029

i need audio driver for acer aspire t6524 for windows 7 ultimate

Repair PC
press delete at startup
go2 BIOS option
1ST BOOT DEVICE CD/DRIVE
2ND BOOT DEVICE CD/DRIVE
F10 SAVE
RESTART PRESS F12

Have you tried System Restore? Restart your computer and watch for the screen to give you instructions at the bottom. It will say something like: F1 = Boot Menu F10=System Restore
It should walk you through a factory restore, which means it will take it back to factory settings the same as when it was perchased.

Hardware fault. Simple test: if you can boot in the BIOS then the hard disk has died - replace it and reinstall. If you can't the the motherboard has failed - in the end it will be easier and cheaper just to get a new pc.

Hello

Try f2,then let the screen come up.This is your bios settings,dont change anything.

Next hit the esc key,answer yes or y key.Pc should reboot normally.

If this doesnt work hit the f10 key and select your hdd or hard drive in the options,and reboot.

Disconnect all devices from the power supply EXCEPT the motherboard
Remove any extra cards including video etc.(plug monitor into the onboard)

If you hear any beeps these can indictate where the fault is.
either of these sites below will help you further with that

Beep codes Pc

More beep codes

Power up the pc and see if the fans are working.
If not then double check the power connections to the board.

If you still have no fans it is time to suspect the power supply as the probable cause.

If the fans worked then you should have gotten a display which told you there was an error and offering you a chance to go into the BIOS. ignore it and shut down the PC.

Now connect one drive only and boot again.

Repeat that until you identify the component that is giving you a problem.

Once you find the problem then remove or disconnect and carry on with the rest to see if another component might also cause a problem

If there is only one problem device then you may want to investigate that device further, Unless you don't mind replacing it

hello...the exact problem on the CPU/unit is Memory so you need to try clean the memory or try to replace a new memory...Thanks and Good Luck...

Sounds like a processor or cpu failure.

Beep Codes

Please vote if you found this information useful.

Thank You