TOSHIBA E STUDIO 280 CALL FOR SERVICE

Here is the verbage for the error code at this link
http://printcopy.info/?l=en&mod=erc&brand=Toshiba&model=e-Studio%202006&code=C413

In the interim you may try the following one time to see if it is a false error... Hold "0" and "8" while turning on machine.....continue holding until machine enters service mode. Enter "400" press enter. Enter "0" press enter. Power off / on. If code returns, machine needs parts replaced. Contact your Toshiba technician (there should be an 800 number label on the unit for service. Do Not keep resetting, may cause damage to Fuser Unit.

Practically you can exit by pressing 0&9 together and it will come to ready mode.You will see this kind of display only when you want to enter the service mode, now you will have to enter a value eg., if your machine gives error c44, then you can go to service mode and then enter 400 to reset the error.

Toshiba e-studio Error code c440 is just problem with Fuser Unit after warm up time . 200L/ 202L/ 230/ 232/ 280/ 282/ 283/ 233

PROBLEM:
Fuser unit problem,


SOLUTION:
Try to reset it:
1. Hold down "0" and "8" keys while turn on the power.
2. Enter 400 press Start.
3. Enter 0 press Set or Enter.


Hope this helps

you can find more info at this link

It is a problem with the fuser called as the oven
Turn the power switch off
switch on by pressing both buttons "0" and "8"
enter "400" and press "enter"
enter "0" and press "enter"
turn off the copier and then on again
Guillaume specialist TOSHIBA
Join me at +225 57 03 73 60

c440

You can use the Toshiba e-studio 160/200 service manual for this machine,
Enter 08 Service mode and:
check these addresses
340 Drum counter end setting. Drum Life:160 and 200 are 27,000 copies.
250 is 33,000 copies. If set to 0:Nothing displays.
673 Resetting drum related counters (08/355 and 08/401) works only if 08/869 is set to 1=SRU, if set to 0 is=CRU.
SRU: Service Replaceable Unit.
CRU: Customer Replaceable Unit.


Good Luck

Call a Service tech
Have him reset yor Counter AFTER he over checks your copier and inspects the Drum,.Transer Unit, and Fuser Unit chances are the previous tech may not have reset the counter
but call for Service to verify those parts are good first ok. I would not want a counter reset to occur if a fuser unit is bad or something. At that low copies it maybe time for corona's to be replaced.

http://www.copierspluswwllc.com

Yes absolutely, however do you know how to get into the Servie Mode ?

if not you can try to " USER TOOL" if you go into it you can select reset to factory reset' I can Not tell you how to go into the service mode, since I am not sure your a Toshiba Dealer like our company, I can not devolve that knowledge Sorry , if your not in Ct then we can not assist you further.

Hello sir; H2 code require reset procedure as follow;
1, press "#", "interupt", "c", "interupt" these 4 keys.
2, enter 14 then press start.
3, turn power off and back on .

Press alternatively Contrast mode Key(Auto/Text/Photo) and cancel "c" Key to enter service mode, while entering into service mode everything goes off, then press 14 and print(start) then turn the power off and back on. if u still have the same problume check the heater lamp and thermister(H2 problum is related with low temperature)