NO WATER COMING IN TO WASHER FROM FACET - Frigidaire GLTF2940F Front Load Washer

If it is an older water line you could have corrosion built up in the lines coming up to the tap. causing the dribble.

A couple of things to check also:
1. I am assuming that you have checked the shut off valve that is usually inside the garage. Make sure that the valve handle is aligned with the pipe, if not turn the handle so it will be aligned with the pipe.
2. Toilet, flush it and see if the tank is filled up again. if the tank fills up right away, then your problem will be in the faucets.
3. Test your shower. If water comes out of the shower heads, then your problem might be in the faucets.
4. How old id the house? if the faucets are not being used regular basis, your seals in the faucets might have hardened up and sticking.
5. hope I have given you some help in trouble shooting your water problem. Good luck.

If the release valve referred to is the pressure release valve, then a water leak out the attached vent pipe is an indication that the valve is failing. To change the valve, the water must be allowed to cool (turn off AC power or gas) and the water level inside the tank must be lowered (drained) to below the level of the pressure relief valve. Once this is accomplished the vent pipe is unscrewed from the relief valve and the pressure relief valve is unscrewed from the water tank. A new pressure relief valve with a sealant on the threads, is then screwed and tightened into place with the outlet port facing downward. The vent pipe is attached to the new valve and the tank refilled with water. A hot water facet must be opened to allow air to exit while filling. Upon becoming full (water will begin to flow from facet), turn off the facet and restore AC power or gas, therefore allowing the water heater to heat up. When the first hot water is utilized there may be some air expelled from the facet.

possible blocked filter

Try this.Turn water off. Remove tap completely. Replace washer correctly.Use special tape on thread(clockwise) it will undo the tape otherwise,,,Hope this helps

Be sure water is coming out of facet to machine. Check water inlet screens for blockage unscrew the hoses going to the machine the screens will be there in the valve . You can take a small screw driver or something and pull them out and clean. Check water valves should hear them humming when on. Be sure timer is set right.Check fill switch and hose going from fill switch to tub it's a small plastic tube you can take it off the fill switch and blow in it to be sure it is not stopped up.
Hope this helps.

Hi,

If your washing machine will not fill, only hot or cold will fill or is slow to fill then read these tips. I have covered many of the things that can happen in these tips...


Washing Machine Problems No Water

Washing Machine Fix Washing Machine No Water

heatman101

Sounds like you have hard water.  You need to change the inside of the facet.  before doing anything make sure you CAN get the parts for you facet.   Danze are not very expencive you might just get a new facet.  If this is a hard water problem you might want to buy a moen facet with a life time warrinty.  More money but free replacement parts.

There is something in the line or in the faucet.Are your pipes going to the faucet black iron or galvinze.Some of the pipe will rust up and stop a full flow of water.But I would check the faucet first to see if the screw is loose or somethng in it.

Replace the cartridge even if its new. The vibrating is from the internal workings of the stem. It also effects the volume of water.


good luck, Phil