I own a Samsung HL-P5063WX/XAA (for a few years now) & have finally decided to make the most of my HD-ready DLP by experimenting with Blu-Ray, DVD Upconvertor, etc. I purchased a Samsung Blu-Ray with HDMI cable 2 days ago (from Best Buy)- it worked beautifully for 15 minutes, then I turned it off. I turned it on again an hour later, but suddenly "No Connection" is available. Have tried all troubleshooting tips (relating to the Blu-Ray, assuming that was the problem) and spoke to tech (who had me repeat same steps), but to no avail. I decided that a day & a half was enough time wasted, so I returned the player & HDMI cord to BB, decided to exchange it for a MUCH LESS expensive Toshiba DVD Up-convertor (along with a new HDMI cord)... still experiencing the exact same problem. No Connection. Have used canned air to clean the once-used HDMI port (thinking dust could be the issue), but no improvement.
For grins, I hooked the Toshiba up to a new, small Samsung LCD TV in my office (via HDMI) & it works beautifully. Any suggestions how to address so that I can use it with my big Samsung DLP-TV?? Any help would be VERY APPRECIATED (I'm totally frustrated!!)
The connector board inside the tv is the one has circuit traces already broken. there is nothing outside the tv can be done. The HDMI conector is high end technology solder. finally the solution is to replace the conector board inside the tv.
268 views
Usually answered in minutes!
×