Viewsonic N3260W made loud pop and will not turn on.

The problem of your tv is in the power supply. In order to find the power supply of your tv ,you should follow the ac cord. But first you should unplug the unit and open the back cover of your tv there you will find the power supply, try to check the capacitors, it is cylindrical shape and has a plastic cover. Try to observed if their is a wet mark or oil mark that spread in to the pcb then replace it. But when replacing the capacitor you should observed the polarity of the capacitor and replace it exactly the way you pulled it out.

did the unversal remote work, if yes then the issue is with the remote. did you contact the viewsonic for a new remote.

try 760... if not, I don't know

This is the instruction for my N2750/3250 remote.
Resetting Remote
• To reset remote and access default settings press and hold desire device button for roughly six seconds and enter three digit reset code 000.

• Replace batteries if remote control keys are not functioning properly, this is a normal behavior that indicates batteries are low.

N2750 IS 008

N1700W
001
N1300
002
N1500
003
N1750W
004
N2010
005
N2010-E
006
N2700W
007
N2750W
008
N3020W
009
N3200W
010
N3200W-E
011
VPW4255
012
VPW5500
012
N2000
014
N3000W
015


Email me if you want me to send you the full PDF from VIEWSONIC, [email protected]

Hi,
You can buy power supply board/ module of Viewsonic N3260W from Shop Jimmy on special price, $65 only.
Thanks.

I do not know the exact value but if you trace out the copper trace from the rectifier output, it should go to the first filter cap and then there will be an inductor and filter cap after that, you can figure out the voltage rating from there. You can get the parts here: http://www.shopjimmy.com/catalogsearch/result/?q=ViewSonic+N3260W
Look here about caps: http://en.wikipedia.org/wiki/Capacitor_plague

Pictures of the power supply will help. [email protected]

try code 1441

Try and re-do your codes for your remote. If you don't have the codes try this.
Here you go. This will work with most all universal remote controls. If you don't have the code do the following:
Automatic Programming
With automatic programming, the remote control tests all the codes available on the Code List and assigns the correct code for the selected device. Although this method can be more time-consuming, it eliminates the need to look up codes and enter them manually.

1. Turn off the device with which you want to use the remote control.

2. Press and hold the corresponding button on the remote control
(TV, VCR, SAT, DVD, CAB or AUD) until POWER INDICATOR illuminates. It should take a couple of seconds for the light to remain solid. The remote control is in programming mode.

3. Press and release power button. The POWER INDICATOR flashes once and stays on indicating the unit is in Power Scan mode.

4. Press CHANNEL up or CHANNEL down repeatedly until the device turns on.

5. When the device turns on, press OK to store the code.

Note:
• To exit without storing the code, press BACK.
• T he unit will search for the next code or the previous code if you press
CHANNEL up or CHANNEL down after the device turns on. (go slow you need to press OK when the TV turns on) if you mess up turn TV off and start over.
6. Press any other button. If the device responds, the remote control has been programmed. If the device does not respond, repeat steps 2-5.

Fill free to ask me questions about anything..........................

cap blew on power supply these tv's have the same problem.

This Works For My Viewsonic N4621W Code 10054