Rotor doesn't stop after insert DVD

130. (10000010) Single Rotor Position Sensor Error
The Motor Control Module has found an error in the pattern received from the Rotor
Position Sensor. Likely causes of this fault are a bad connection on the harness between
the Rotor Position Sensor and the Motor Control Module, or a faulty Rotor Position Sensor.
Primary Source: Wiring.
Action: Check for corrosion on the RAST connector of the Rotor Position
Sensor and the Motor Control Module connector.
Secondary Source: Rotor Position Sensor.
Action: Check the Rotor Position Sensor with an R.P.S. tester. Replace if
faulty.
Tertiary Source: Motor Control Module.
Action: Replace Motor Control Module.
Quaternary Source: Rotor
Action: Ensure the correct rotor for this phase of machine has been fitted

It generally has a long rotor through bolt accessibile from the generator end, this forces the generator rotor onto a tapered shaft on the engine. Once removed the through bolt slide a long bar ion the hole and screw the bolt back in, that will force it off the taper

DID U PUT IN THE RIGHT FIRING ORDER

CHECK POWER AT THE PUMP, MOTOR BUZZES ? YES CHECK TO SEE IF ROTOR TURNS, YES CLEAN START SWITCH, HAVE CAPACITORS CHECKED , NO ROTOR DOESN'T TURN MOTOR WILL NEED TO BE SERVICED. ROTOR MAY HAVE RUSTED TO STATOR OR LOCKED UP BEARING .. JAY THE POOL PUMP MOTOR REPAIR GUY IN LONGWOOD FL

Yellow means weak spark should be blue check the coil tower where the coil wire attaches on the coil for corrosion. Also check the spark plugs for wear.

are u sure it,s spark and not the fuel pump relay?...when u have no spark..it never starts period ....

get rid of dodges

when the engine is a top dead center on cyl one put the distributor in so the rotor points to the no1 spark plug wire trminal on the cap try that let me know if it helps

One of two things has happened. You have a damaged wheel / tire assy. One of the wheels is bent or the tire has a bubble. Or you have a warped brake rotor. Most likely it is a front rotor - but can be any one of the four. To ck for a bad tire wheel assy. Jack up the car each tire one at the time, and spin the tires looking for a out of round side to side motion. Also at the same time you can ck for a warped rotor by spining the wheels and have some one easy step on the brakes if you feel one spin free then lock up then spin free that is the bad rotor. 

i would say for some reason your dvd player is not compatible from now on with that brand of blank dvd!


get the firmware update from the brand website all you do is download the file burnit on a cd and put it in the dvd player should fix most and eventual problems