Will not spin

Your question is confusing. A washer doesn’t spin when it washes. It agitates. A washer fill with water, agitate, drain then spin water out. Please reword your question.

you need a new lid switch google model number and order new one

Possible fault with the program controller unit. You need to check the program cycle outputs using a multimeter connected to measure the output voltage. On start the inlet should open and then close as the water level sensors works and then proceed to wash. So this much seems OK. Now in the next step the drain valve must open to drain off, then fill once again with the inlet working and water level being sensed. If there is no output in this section cycle then the prrogram controller has errors within the memory . You can remove the panel and reset all connectors and connections.

Sounds like the fill switch needs to be replaced. A good way to test it is to set your machine on low fill and see if it fills past 3/4. If it does, it's the fill switch.

WASHER FILLS WITH WATER, THEN WON'T AGITATE. TURN KNOB TO SPIN AND IT DRAINS THEN SPINS. STILL WON'T AGITATE please show me a diagram

check the lid switch if its ok
you have a problem with the timer
replace it

I recently had this problem. It was found that the main drive belt broke and the washer would fill but not spin, agitate or drain. I replaced the belt and everything worked again. A defective or disconnected cover switch would also cause the same problem.

Leaks water...check the pump first. The fill valve and hoses may be the next step. See how to take apart info. With the use of plastic drain hoses on many machines today, this has become a common leak trouble maker. The drain hose can rub the wall or a pipe and this will rub a hole in the drain hose.
 

1. Agitation problems and agitator dog repair aid info
   
2. Automatic dispenser information
   
3. Common problems with Inglis, Whirlpool, Kenmore direct drive style of washers
   
4. Diagnostic Direct Drive washer chart from American appliance
   
5. How a washer works, good to read this first
   
6. Help for storing an appliance
   
7. How does the agitator come off my washer ??
   
8. How to prevent socks from getting into your pump
   
9. Ohm test a common direct drive motor
   
10. How to by-pass a lid switch for testing the washer
    
11. Basic information: Inglis, Whirlpool, Kenmore Direct drive washers
    
12. Inglis, Whirlpool, Kenmore Direct drive washers - How to take apart - Cabinet off, cabinet on, checking or replacing a lid switch, replace the pump, replace motor coupling or motor.
    
13. Inglis, Whirlpool and Kenmore direct drive washer- useful parts breakdowns
    
14. Important disclaimer
    
15. My direct drive washer will fill ok, agitates ok but when it comes to the spin and drain cycle the washer comes to a screeching halt...no spin, no draining and the timer stops, what's up?
    
16. My clothes have a whiting on them that looks like lint.
    
17. My washer has a funky odor
    
18. Noises
    
19. Ohm meter testing a motor capacitor
    
20. Slow water fills
    
21. The wash tubs on my direct drive washer are leaning to the right...why?
    
22. Timer stalls or missing cycles
    
23. Timer will not advance
    
24. Tips on changing a common washer fill valve
    
25. To learn more about washing machines, click here
    
26. Washer Basics: Filling with water
    
27. Washer leaks water
    
28. Washer moves around to much
    
29. Washer will not spin
    
30. Washer sample wiring diagrams
    
31. Washer spins and agitates at the same time
    
32. Washer belts: If your belt on any washer looks like these, replace the belt(s).
    
33. Washer runs but wont agitate or spin
    
34. Washer won't run, agitate or spin
    
35. What is that black power powder or filings under my washer??
    
    
    

No agitation or spin in any cycle? If so and the machine will drain check the coupler.