Entering code in radio intergra intergra 95 - Acura Tl 2002 Stereo/radio Dash Wiring/wire Harness

When you disconnect your battery and then reconnect it again, it disables the radio. This is an anti-theft protection for your car radio.
The enable your radio the activation code is in your vehicle owner's manual. If you do not have this code you need to go to your vehicle manufacturer's service centre and get them to enter this code for you.

Did you check the fuse? If not, the fuse for the horn is located in the fuse box in the engine compartment (see picture of location below). The fuse you will be looking for is in the number 2 position and should be a 20 amp fuse (see layout diagram below). I hope this helps and good luck.

i think you must put the numbers and then use volume button as "enter" that's it

Fuse 35 (7.5A) ACC RADIO. interior fuse box (under the steering column)
How this helps you find it.

There are no codes in Nissan vehicles for the radio. Nissan has never used the security radioes. If it is a factory radio I would check the fuse first.

the neutral safety switch is probably faulty the radio says safety because the wrong code was entered 3 time key needs to be on for 3 hours hook up battery charger check engine light may be code for trans issue

Have you checked your codes to see what the car is asking for?Most times a vehicle computer will do a fuel tank vacuum/pressure check when decelerating.

go to "http://support.radioshack.com/support_electronics/16429.htm"
I did not see any "codes" there, the manual is there. good luck!

If you have that nifty little radio code card that your vehicle come with when it is new then you just simply use the number keys on your radio to enter the code. If you don't have the card then you will have to take it to the dealership and get them to look it up.