Washer lost power right at the end of a load. not breaker

check pump

If you are not getting anything on the display, then the CCU has gone out and will need to be replaced. Here is the part to order.To access the CCU, remove the screws on the top panel, slide the panel back about a 1/4 inch and lift off. The CCU is located at the front right hand side. Take not of the wire connections. Be sure the unit is unplugged before replacing the CCU.

The part comes with a 365 day, any part, any reason return policy.

Too many clothes
washer door not opened between washes
low power/extention cord
kinked hose
Door not shut tightly
hoses connected backwards
inlet screens clogged
circuit breaker tripped
unbalanced load
excessive suds
wrong detergent
Repair Manual


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Plug a working lamp in the washer power outlet. If it lights, the problem is within the washer (look for a breaker button on the back of the machine). If the lamp doesn't work either, look for a bad breaker, a loose neutral wire connection, or loose wire connection on the breaker. Check the wiring on the washer end as well.

There is probably a little trap door on the front of the machine right near the bottom. Behind this, you will find what looks like a large screw cap. If you undo that, you will release the water from the machine (it's the lint trap), so be prepared for a lot of water with a few buckets or bowls that you can put under it. Once the water is out, the door should release

no fuses only control boards.with power off pull the top off and check wires at your power supply board(not the one with buttons). Look for burn or damaged wires. no luck with that, will probably need power board(usually the board that goes out). Call LG and speak to cust service....sometimes will cover the board.

The dryer is on a different circuit as it is 240 volts. Look in your breaker box and find the breaker for it (it should be tripped half way). Turn it completely off and then back on. There is no reset button for it. Make sure the plug is securely pushed all the way into the outlet.

dryer tub loose

Unplug washer or disconnect power.
2. Remove the lower kick panel.
3. Reach up along the inside of the front and locate the bottom
of the door switch/lock unit.
4. Located on the bottom of the door switch/lock unit is a
tear-drop shaped tab.
5. Gently pull the tab down about a ¼" or until a click is heard