Foxconn n5235 mother board manual - Foxconn (755A01-6ELRS) (K8S755A6ELRS) Motherboard

http://www.freeproductmanual.com/foxconn-ls-36-motherboard-manual/pdf-manual-foxconn-ls-36-motherboard-manual/
GREEN POWER.
BLUE STAND BY.
YELLOW MEMORY.

Go to the Foxconn website. All the manuals you need are there.

make sure the aluminum tower is covering black chip on mother tight with metal clasp on alumnium tower is covering chip make sure fan is properly tight on mother board make sure battery in mother board is in and make sure fuse is in mother board then restart push f2 and start your reboot....

open side panel remove cable from usb reader i have pulled CABLE AFTER install new mother board same thing stuck no key board 1 blink/ f10 got setup ..... stuck . This may be a chip set driver not installed. or a bad hardware pulling to mush power. I change CPU, MEM sticks. Power supply all the same thing. Just pull these cable to hadrware not hdd. boot right up . BINGO> down 1yr.

there is a label on the mothereboard on what connector you will put..youll see hdd,pwr something like that

Hi,
You can try going to the following site and download the user manual for the motherboard , which would give you the detailed diagram of which cables to connect where
http://www.foxconnchannel.com/support/downloads.aspx?ProductModel=661FX4MR-ES&TypeID=en-us0000001



Thanks
proton

SP2 usually has USB drivers inside!

http://www.foxconnchannel.com/product/Motherboards/detail_overview.aspx?ID=en-us0000066

here is all youshould need i dont understand whatyou mean but this is where you can get the specs for this motherboard

You can go to this website, select the proper motherboard, and it will give you all the detailed specs of that motherboard.

Thanks and please take a moment to rate as fixya.

Hi, I run a foxconn mobo myself and yes its a great board. But dont go to the foxconn site looking for downloads. instead go to the VIA site they make the chips and you will get more sense there. If all else fails Foxconn do have a "Contact us " link on their home page. This will give you the company email address and you could request directions to the update site there, the only trouble is it could take weeks to get a response. Regards mistyman