Need to replace the jockey pulley kit on a fisher paykel dryer

SOURCE: Fisher & Paykel DEGX2 Dryer. Need heating element changed?

I had the same problem. Everyone continued to tell me that I needed a new heating element, clean lint trap, etc. However, I took the front off of the dryer and located the heating element. On the front of the heating element, in between two wires, there is a red button. Push the button and you might hear a click that sounds similar to a circuit breaker. It is a reset button for the heating element. Try that and it might help.

SOURCE: fisher paykel dryer DE04-US6 just get a buzz sound

Open up the door and push the door switch and hit the start button and try to turn the drum by the baffle in the dryer and it it starts to go then you need a new motor.

Testimonial: "Held the door button in...pressed the start button...spun the dryer drum...and it started spinning...i.e. bad motor. nice work thanks"

SOURCE: Fisher & Paykel Auto Sensor Dryer stops & beeps constantly

Hi emkboyce

my Fisher Paykel auto sensor dryer keeps stopping and beeping, i have to stop it and and re start.

I had the same problem. I took it off the wall and vacuumed up all the lint from everywhere including around the back and including taking off the back and vacuuming everything I could reach inside. I then used a damp cloth to get rid of the rest of the lint/dust.

I thought I was wasting my time but guess what, the problem has gone.

Good luck!

SOURCE: need a manual for fisher and paykel drier ED56

try here http://kitchen.manualsonline.com/ex/thread/view/idThread/2200997
cheers Sandy

SOURCE: my fisher and paykel dryer ( mod# ED56 ) wont start, power is on

I had this same problem with my Dryer. It is making the few quick beeps because it thinks the door is still open. Near the bottom of the opening to the dryer there is a sensor switch that gets pushed in when you shut the door. Try holding the switch in with a knife or something and then start the dryer with the door open to check if that is the problem.
After i did this, i closed the door and my dryer started as normal.