1) Lube the deck belt use 100% silicones or wax, read your instruction manual
2) Lube the rollers bearing use wd-40
3) Replace fuse and see if is o.k now
4) If the problem persist you must test the tension for drive belt motor, and adjust it according.
5) Test the input voltage motor, see my personal TIPS for motor help and troubleshooting.
6) Use the treadmills directing from the source DO NOT USE any extension power cord!
7) Test again if the problem persist,now you have power supply or control board faulty. see the block diagram.attached.
God bless you
SOURCE: Proform 570 blowing fuse
there are generally two control boards, I am assuming you looked at the lower one. I would first disconnect the power leads at the board and see if it still blows the circuit breaker (fuse?). If it does the check wiring for short. If OK then reconnect power leads and then disconnect all other wires (plug-ins) to the board and try again, each time plug a connection in and retry. (remember to disconnect power each time). I have a feeling the smoke got let out of this lower board and may need replacement. hope this helps
www.twincityrepair.com
SOURCE: Proform 545S needs replacement walking belt
Here is the replacement part page for iconfitness.com
www.iconservice.com/CustomerService/partsModelSearch.do
470 views
Usually answered in minutes!
×