You can't get any Free Code if your Mobile is locked by any Service Providers. If it is Locked so, Unlock your Samsung SGH-T459 Gravity Phone by Clicking this site http://www.onlinegsmunlock.com/. Follow the Instructions:-
1 - Switch ON your Samsung SGH-T459 Gravity without any SIM Card.
2 - Compose : #7465625*638*CODE#
SOURCE: samsung SGH-x475 t-mobile unlock code
sure the unlock code goes as follows... *2767*6903557610011172#
after you do that it will seem to shutoff but leave it and it will then open up to working screen... you will have to enter this code each time you turn off the phone but it should work,,, if u have any questions... e-mail me at [email protected]
SOURCE: I need free unlocking codes for samsung E590
hai, I agree with venkat. But i also found the site called http://www.mobile-unlocker.com/.It's also having the code and instruction for samsung mobile.
SOURCE: FREE samsung sgh-t239 sim subsidt unlock code
Whats the code required to unlock the samsung SGH-T239 Phone IME # 011841 00 030683/101
SOURCE: from where I get samsung sgh-t459 usb driver
They do not make one for your phone, and they do not have you phone setup to work with the samsung pc studio.
So the only thing you can do is this, and maybe pictures.
Testimonial: "as its the only option i have these is very helpful thanx"
SOURCE: how to take apart the samsung gravity sgh-t459
Remove battery cover and battery. Using a #00 philips head screwdriver, remove the 6 screws around the perimeter. Slide phone open and carefully pry up on the edge of the green (or blue) trim near the space bar. The colored back should unsnap. There will be two philips head screws visible on the now exposed circuit board. Remove these and carefully pull up on the rectangular ribbon cable to disconnect the main circuit board from the keypad circuit. Carefully peel the two button contacts from either side of the phone. On the spacebar edge, there will be a clip holding the circuit board in place. Gently pry it away from the board and the board should come free (there will be clips on the other side but you should be able to lift the free side of the board up and slide it out from under the clips). Remove the QWERTY keypad. Unglue the remaining ribbon cable from the keypad frame. Undo the 8 silver screws securing the keypad frame to the hinge and lift frame off. There will be 4 screws visible on the back of the LCD case. Remove these and insert a thin plastic spudger at the top of the frame and carefully work your way around. The two halves will separate (should hear two snaps on each side). You will now be into the keypad/LCD section of the phone. Removing everything else is pretty straight forward. Follow these directions backwards to reassemble.
403 views
Usually answered in minutes!
×