Good Day to All!!!. This morning an error code "A041" appear in my Kyocera Mita 1510, I already checked connections, but it doesn't still work out. "Your suggestions in this regard is highly appreciated.."
SOURCE: ERROR CODE 630 KM1810
replace the fuser...
I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d
SOURCE: How to fix Error code C6020
Order the modified fuser plug connector. There is also a later firmware update to fix this code. This code happened to me on a few selected machines after I did firmware upgrades to add the interrupt button on the touch screen and to speed up the loading time. The thermistor is not guilty!
SOURCE: kyocera mita km 1510 signal
Broken fixing heater wire Check and reinstall if necessary. • It takes 24 s or more for the fixing temperature to reach the secondary stabilization fixing temperature from the primary stabilization fixing temperature. Fixing unit thermostat triggered. Check for continuity. If none, replace the fixing unit thermostat.
• It takes 15 s or more for the fixing temperature to reach 50°C/122°F after the power is turned on or the safety switch is turned off and on.
Fixing unit thermistor installed incorrectly.
• It takes 10 s or more for the fixing temperature to reach 100°C/212°F from 50°C/122°F.
SOURCE: We have a Kyocera Mita KM 1510 and I am getting an
C 710 is a Toner Sensor Problem
Defective toner sensor - Replace toner sensor
Poor contact of the toner sensor connector terminals - Reinsert the connector. Also check for continuity within the connector cable. If none, repair or replace cable.
Developer problem - Replace developer.
71 views
Usually answered in minutes!
×