Clarion dxz545mp amp guard

This answer will require a very detailed technical solution, therefore I recommend contacting a local car audio professional or Clarion customer support directly here:

https://clarion.com/xe/en/user-support/inquiry/contactus

I trust this information proves beneficial.

Have you tried 1st to pull the unit out of the wall using the little metal "keys" to release the deck from the mounting cage and than pull the power plug AND the Satillite plug as well and wait for 10 minutes or so and replug it but first hit the reset button and see what happens. I run into this frequently with Clarion's in boats/yacht, not sure why but i guess it could be result of a voltage surge. Now the display is saying that you have a blown speaker or more than likely a wire that is grounded out. I highly doubt the charter client caused the head unit to shut down other than the simple act or ejecting a cd. We quit selling Clarion for that very reason, an abnormal rate of repair occurances. And I would wager you have the hard wired remote controls either on the bridge or in the rear at the swim platform or both locations. These too could be the problem. I can't tell you how many hours i have spent running down a shorted speaker wire. Because if one is shorted in the "slightest" you get the message "amp guard". If push comes to shove Captain i recommend a small amplifier and use only the pre-outs (rca cables) instead of speaker wire. Good luck and let me know if i can assist you because i work on a lot of watercraft believe it or not in Arizona and most are over 34' Cuddys like SeaRay SunDancers etc. good luck... Mark @ Sounds Good to Me [email protected] if you want to reach me direct. I still have Clarion contacts too.. mark

Leave the radio powered up for up to 2 hours, the reason for ERROR 6 is the incorrect code has been inputted.

well over time the cd reader in side the unit goes and that what is happen to your unit best solution replace the init

here is the owners manual for that stereo

http://www.clarion.com/ca/en/MungoBlobs/754/615/DXZ545MP(Manual),1.pdf

please take a moment to rate this solution.. thanks

Blue white is remote to amp.... Grey and black are your RCA out to amp...

, the message you are getting is "amp guard". This is the mesage it will display when a short in a speaker wire or speaker with low impedence is hooked to the internal amp and sends it into protect mode, shutting down the amplifier section while the rest of the unit continues to work.

check all of your speakers

, the message you are getting is "amp guard". This is the mesage it will display when a short in a speaker wire or speaker with low impedence is hooked to the internal amp and sends it into protect mode, shutting down the amplifier section while the rest of the unit continues to work.

check all of your speakers

the message you are getting is "amp guard". This is the mesage it will display when a short in a speaker wire or speaker with low impedence is hooked to the internal amp and sends it into protect mode, shutting down the amplifier section while the rest of the unit continues to work.
Check your Factory speaker locations for blown speakers or bare wires to metal.

Check the fuses in the fuse block under the hood. Your clock fuse and radio constant power fuse are combined in this vehicle.