I have a problem getting a new pass word as it won:t except my code no . is there any other way of getting a new one ? thank u .

if you are not the rightful owner u can get the pass code except you reload the ios

Install a new needle. Remove the needle plate and look to see if the tip of the hoop passes above and close to the eye of the needle. If it does not you have to re time the sewing machine.

http://www.radio-code.lt/search-radio

There can be more than one sensor in the system. But here is what happens when your old sensor goes bad. The fuel mix can go rich and this results in a buildup of soot in the catalytic converter.

Sometimes the catalytic converter can recover over time. There are cheater additives which go in the gas and may help you pass the test.

You need a better diagnosis of your potential problem. The onboard computer in your van will not Code every problem and has to be showing a "check engine" light to display any problem.

However, better Scanners (Some costing thousands) can probe the system and reveal many defects.

New sparkplugs, clean fuel injectors, can help lower emissions. Just remember that an additive which dissolves debris on fuel injectors can also send that debris to your Catalytic converter.

Now as far as running it "forever", you want highway speeds, which in terms of RPM is about 2000 RPM on many vehicles. You can shift out of "overdrive" and this will keep the RPM higher at a slower speed, but it needs to be above 45mph to be effective. Your overdrive does not always kick in below 45, so to make a difference using my tip would require driving above 45.

Look up the drive cycle on google for your car.

you have done everything except replace the heated oxygen sensors in the exhaust manifold pipe/s and run the fault codes
you have replaced a lot of good parts that were not necessary to replace

A "band pass" filter attenuates all frequencies except those in its specified range. A "low pass" filter attenuates frequencies above a specified frequency (permitting only lower frequencies to "pass"). A "high pass" filter attenuates frequencies below a specified frequency (permitting only higher frequencies to "pass").

For example, a "band pass" filter rated for 500MHz-4GHz will effectively eliminate all frequencies below 500MHz and all frequencies above 4GHz. A "low pass" filter rated at 10KHz will effectively eliminate all frequencies that are above 10KHz. A "high pass" filter rated at 70Hz will effectively eliminate all frequencies that are below 70Hz.

pm me on this number sir if your car is not yet fix 09151765130

Hi
You can get you LG300 unlocked at LG UNLOCK CODE website

Unfortuntely the code above does not work as it was changed again. Anyone got a new code for NTL in Luton?