What does the code od mean? - Maytag Neptune MAH5500B Front Load Washer

2001 Chrysler PT Cruiser
WRONG CODE POSTED , LAST DIGIT MISSING!
P040X IS ,, EGR SOME THING.
401, to 406 are all EGR errors.
it means EGR is failing and can be very hard to cure.
ever clean out a EGR exhaust path ,full of carbon, a days labor. or more.


WHAT IS AN OD SENSOR. ???????
OD ON CARS MEANS OVERDRIVE AND P040X HAS ZERO TO DO WITH OD

NOT TOLD ANY SYMPTOMS.
ZERO STORY TOLD AND THERE ALWAYS IS ONE.
engine dead , or stalls or misfires. or lacks power.
transmission problems
or smog test failed, and now ask why.
what engine is here. 2.4L?

i lucky #2 is bad.

https://www.engine-codes.com/p1782.html P1782 2 4 OD Pressure Switch Circuit

Low Battery Voltage Low transmission fluid level Dirty transmission fluid Faulty 2/4-OD Pressure Switch 2/4-OD Pressure switch poor electrical connection 2/4-OD Pressure switch circuit is open or shorted

Read more: https://www.engine-codes.com/p1782.html

www.ask.com/mfg.name/make/model#/what-does-the-OD-code-mean/

od meaning from the Service Manual for the FAV6800A/FAV9800A;
Open the Lid: The lid has not been opened for the last three completed cycles.

The OD and OP error codes are trouble shot the same way. See if this link will help.

Left Hand Lid Lock Troubleshooting

FAV6800A/FAV9800A Service Manual for reference. Sears Parts Direct for reference

If you need additional help let me know.........D*ick




D*ick

Yes, OD is a open door error code. You may need a new door latch assembly. pn 22002262.

The flashing OD light indicates there is a problem in the transmission control system. When the Transmission Control Unit detects a malfunction it will flash the OD light and store a Diagnostic Trouble Code (DTC) in the computer. You will need to have a Ford Dealer pull the codes and determine exactly what is wrong.
I wish I could be more specific, but there are about 120 different reasons for the flashing OD light.

error code OB turn off the printer, why?

od code is supposed to mean that lid has not been opened for the last 3 completed cycles. Also, apparently you tried the service mode and found the door lock to be working. So, unless the problem is with the electronic board itself the only other thing that could be happening is a faulty sensing switch at the door lid or a bad connection to it. I would try shorting the leads from the switch and see if the problem goes away. Then you might just need a new switch.

check to see if the switch button is depressed.

Could od mean overload? Reduce or actually weigh load and re-try