I just replaced Q1, Q2 and D3 to solve my previous problem (after shorting out the target lamp). I now however have the problem of low torque. The platter spins up slower than my other deck (about 1/4 of a rotation slower) and then takes less pressure on the platter to stop. When the platter is stopped (under pressure ) the red strobe light seems to flicker? any suggestions what this may be - could it be one of the IC's or just a brake adjustment needed? thanks
SOURCE: technics sl 1210 will not start up
did you ever open the turntable. It sounds like the on/off switch is bad. Remove the platter and screws with a phillips screw driver and just make sure the connections are in place. make sure you disconnect the power first. let me know what happens afterwards.
206 views
Usually answered in minutes!
×