Hello Munybuny,
I've a problem with my ricoh aficio 2022. I opened the machine, through out the heating and the fixation because i've had black tonerpoint s on my prints. When i did pu back the heatimg and fixation in the mac´hine i got the error sc548. Please can you help me?
best regards
Andreas from germany
Hi Andreas: The fusing unit has not been reinstalled properly. There is a receptical on the back of the Fuser that mates with a plug in the machine when you install the part. the machine is telling you it did not detect the fuser. Undo the screws and remove it and reinset it again, makin sure that it seats properly. then you will need to reset the code. Go into SP Mode: Push in sequence; Clear-107-red stop button(hold this down until display changes and shows "copy etc"), turn machine off(using red power switch, wait 10seconds and turn back on. If you still get the error code the fuser still is not inserted correctly. Hope this helps.
PS: Black spots can also indicate a new drum is needed. It may have a small chip in the surface.
Regards
Munybuny
524 views
Usually answered in minutes!
Error Code sc 392 cod
×