I spilled a drink on the MX-500 and need to get into it in order to clean the circuit board. I don't see any way to get it open. Can anyone help? Thanks!
Use a small flat blade (screwdriver, or whatever) and pry around the light button. The bottom connects over the top so try to guide the blade in the crack then down and out. If you get an slight opening, stick a another small blade in to hold it while you continue to pry. It make take a fair amout of force to get the bottom part, start with the top.
You will need to prise it open. I used a small strong knife and worked it between the two halves of the remote. Once you have done it once it becomes easy.
This remote may have a screw under the label on the rear if not it is a 'snap together' type which usually can be prised open using a very thin screwdriver but be careful you dont slip and injure yourself.
599 views
Usually answered in minutes!
I have the same problem; can't get into it to fix the light. I have not found any screws and trying to pry it open has not gone so well.
×