Spin cycle in the washer just started making a loud clacking sound. It also seems to stop much more abruptly than it did before. Seems like something may be rubbing, but spin speed still seems good

SOURCE: "howling" noise during spin cycle (still there after changing burned off belt)

Travioso, there was two service flashes out on this model concerning the seal and bearing which means they had an issue with this washer. The howling noise you are hearing is the bearing and will need the new designed triple seal and bearing kit. This should be covered under your warranty, I believe it is 5 years. The numbers for the service flashes are TDL-0048A-B. Call Maytag and inquire about these service flashes, these should be covered. Catriver.

SOURCE: Frigidaire top-load washer Loud noise during spin

its either the upper spin bearing or lower spin bearing. the upper can be replaced by itself but the lower requires the transmission the be replaced

Archie Ferrarini

• 869 Answers
• Posted on May 23, 2008

SOURCE: Spin Cycle Making Loud Noise

You brake is failing .Replace it.

onthethejob1

• 640 Answers
• Posted on Feb 07, 2009

SOURCE: spin cycle very loud,

spin surpport defective,,,this part is under warranty,,lifetime warranty..contact whirlpool for replacement of spin basket,,onthejopb

SOURCE: Loud noise during spin cycle

is it more like a roar or a train going by? if so your rear tub bearing is going out. very expensive have to replace the tub, basket, spinner ring and shaft and seals about 4 hrs for an exprienced tech to do took me 7 hrs to do for the first time. but it will be very close to $1000 to have done not much less to do it yourself.