I have no remote control or manual for my Bush TV/DVD combo - Have just bought the one for all 2 URC-3426 but I can't set it up because I can't switch the TV on or off it stays in standby can you help me to overcome this problem
When this model is in standby mode Channel up or down should take it out of standby.
While using the URC22B remote try codes
081 119 026
haven't worked out how to get the DVD working properly on it yet but got my telly and aux switch
I am looking for a user guide for a 14" BUSH TV AND VIDIO THE ONLY REFERENCE I HAVE FOR MODEL IS ON BACK COVER OF SET:-BUSH BTV 18/BUSH DFTA 1001 IDAPTOR
SENT BY RAY CHAPLIN
Did you check the casing for a reset button (sometime it an itty ***** hole)
Hope this helps
Trap
If you still have the TV:
Common cure for "stuck in standby"
1. Unplug from mains
2. Press main power switch on/off about 20 times
3. wait about 5 minutes
4. plug it back in and try turning it on as normal (i.e into stand-by then CH+ etc)
It has worked for me on about 8/10 TV sets found stuck this way
0154, 0236, 0463, 0180, 0178,
0171, 0623
The One For All 4 Device Universal Remote Control is preprogrammed at
the factory to operate an RCA TV, a Toshiba DVD player, a Motorola cable
box, and an RCA VCR.To control devices other than the default brands,perform
the following steps; otherwise skip this section:
[1] Turn on a desired device (e.g.,VCR or DVD player) and, if
applicable, insert media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding.
Highlight or write down the codes and device you wish to program
before starting step 2.
[2] On the remote control,press a device key once (i.e., VCR/PVR,
DVD, CBL/SAT,or TV).
NOTE: To program control of a VCR, PVR (or DVR),TV/VCR Combo,
or TV/VCR/DVD Player Combo press VCR/PVR once.After programming
a VCR Combo device, you will be able to control channel selection,
volume, and VCR functions.
NOTE: To program control of a DVD Player,DVD Player/VCR
Combo, or TV/DVD Player Combo, press DVD once.After programming
a DVD Combo device, you will be able to control channel selection,
volume, and DVD functions.
NOTE: To program control of a Cable Box, Cable Box/PVR (or DVR)
Combo, Satellite Receiver, or a Satellite Receiver/PVR (or DVR)
Combo, press CBL/SAT once.
[3] Press and hold SET until the LED (red light) blinks twice,
then release SET.
[4] Use the Manufacturer's Codes (starting on page 18) to
locate the type of device and brand name and then enter
the first four-digit code for your device. If performed correctly,
the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter
the same code again.
[5] Aim the remote control at the device and press POWER
once.The device should turn off. If it does not, repeat
steps 2 through 5, trying each code for your brand until
you find one that works. If it still doesn't work, try
Searching For Your Code on next
NOTE: If the device does not have a POWER key, press PLAY
OK.
http://www.retrevo.com/support/One-for-All-URC-4021-Universal-Remotes-manual/id/2784bh232/t/2/
click on download manual ( you will need pdf reader)
Best of luck..
3,824 views
Usually answered in minutes!
×